You must wear rubber gloves when workingwith carburetor cleaners. The one-gallon size of both products comes with adipping basket. Take your time, and don’t try to Wholesale classic wiper for Sale throw all of the parts in atonce. Keep them separate. As gasoline gets old and evaporates, it canleave a varnish film or gummy residue on parts and in tiny orifices. It's alsopossible some small particles and rust could have gotten into the smallpasغير مجاز مي باشدes and orifices of the carb.  This means that parts inside acarburetor may not move like they are supposed to, and small pasغير مجاز مي باشدes meant tometer air or fuel can become plugged. The varnish or gum will not be completelydissolved or removed with the chemical. A brass wire brush is a big help inremoving gum and varnish. NEVER use a drill bit to clean jets ororifices. Although it doesn’t feel like the drill bit is removing metal, itcould enlarge a jet size. Never use a steel paper clip or sand blast the partseither. If you have to get into a jet or tiny pasغير مجاز مي باشدe, use a piece of copper orbrass wire.  Repeated treatments with the wire and chemical are better thantrying to do it all in one pass. Check the float to be sure that it is notleaking. Immediately upon disassembling the carburetor, shake the float whilelistening for fluid sloshing around inside. After everything has been cleaned,submerge the float in hot water, and watch for bubbles that would indicate aleak. Rotate the float slowly underwater so that all surfaces are given anopportunity to be facing up. Air rises, and the bubbles will be obvious. Againshake the float and listen for fluid inside of it. After all of the parts are completelycleaned, dried and inspected, it is time to begin reassembly. Use the new partsthat came with the rebuilding kit instead of trying to reuse an old part thatstill looks good. A spring may have lost its tension, a valve may havedeveloped a flat spot, a gasket may be too thin in spots. New parts are reliable. NEVER paint the interior of a carburetor.If external parts are to be painted, use Plasticote’s Aerosol Lacquer spraypaint. Lacquer is more resistant to gasoline and won’t peel off or dissolvereadily. Make sure that you do not get any paint in screw holes, access portsor on linkage that has to move freely. When you assemble and then reinstall thecarburetor, tighten the screws in a pattern (generally opposite screws) thatevenly distributes pressure. Tighten the screws a bit at a time, and take atleast three steps to fully tighten each one. This will help put even pressureon the flanges and will help prevent breakage. The adjustment specifications that comewith the instructions or that you find in a Motor’s Manualor Chilton’s is a starting place. The details found in Orest Lazarowich’scolumn, Orest’s Carburetor School in SkinnedKnuckles magazine will give you much more detailed and precise Find out more about Daihatsu S-89 carburetor by visit miparts.com.